Weight: 400 g
Consumption: 100 g / h
Heat: 10,000 BTU
Gas: GAS or kerosene, gasoline, diesel, etc.
The stoves meet the following quality standards: prEN521, CAN1-11 ,2-M79, CSA B140 9.2-1975

:

1, and pre-use check nozzle preheater tubes, and preheating the fuel pipe is close, Ling tight fuel pump and fuel control, and close control valve
2, fuel bottle installed fuel (8-Man), the fuel pump will be fixed after the boost in the fuel bottles under about 10
3, the control valve opened, a small amount of fuel into the preheating Cup (all at the same time observe whether there is a leakage interface), confirmed that no oil spill after the fire ignited by the petrol preheating Cup
4, moments after preheating combustion flame Cup will be a bit blue (This shows that the normal fuel fuel), the regulating valve appropriate to the size, firepower to achieve their demands the use of state
5, the shelves tableware, the whole process should take note of the combustion flame in a timely manner to the fuel pressure and liquidation coke bottle

Note: Oil Furnace must cope with the use of wind and board, on the one hand could wind, more importantly, can improve the safety of



Maintenance:

The most important thing is cleared up coke, the normal use of 3 to 5 hours after the (mainly depends on the cleanliness of the fuel), the burner would produce coke, the coke external cleaning is simple, can wipe with a cloth, etc.; cleaned The key is preheating, the normal burner, such as cooling, preheating tube removed, will be out of metal wire, the wire with a cloth will remove the coke, and then cleaning up preheat tube and nozzle, the general could be soaked with gasoline, then Wire repeated withdrawing clear (it is best to use to replace other metal wire, such as a bicycle brake line), will be re-cleared after the wire and guns loaded back

Sealing gaskets also essential maintenance, use of the seal must be identified, found that oil spills must stop using Oil Furnace promptly after use to clean up the oil within the plot, often to a pump gaskets and piston DiNova ring (lubricants or seal oil)

Other aspects of the maintenance of the fuel is to avoid excessive bending, and usually pay attention to the fuel pump, avoid stained sand, the other is regular checks of all contacts enclosed in